DESCRIPTION
- Efficiency: perfect for Airmix finish
- Optimization: built with minimal parts
- Simplicity : lowest cost of ownership
Technical manual
PERFORMANCE
- Constant delivery and pulse free for superior finish
- Priming at very low air pressure (0,6)
PRODUDUCTIVITY
- Large foot valve to handle high viscosity material up to 5,000 cPs
- A closed construction to prevent from risk of injuries & to protect lubricant from external contamination
- Quick mauntenance thanks to an easy rotable outlet fitting
- Facilitate pump priming & flushing thanks to a design made to eliminate dead zone : time sized
- Leak monitoring vent hole for fast control
- A quiet air motor make very low noise
SUSTAINABILITY
- 45% less part vs competitors for the air motor to provide a better maintenance
- Differential air motor to ovaid the paint pump from frost
- Ultra coated pluger for less friction & improved abrasion resistance
- Single GT seal to avoid throat packing maintenance & low friction & offers a large lubricant wet cup
The 15C25 Compact Airmix paint pump is recommended to handle all types of materials, ranging from medium to low viscosity.
Technical data cable
- Designation Value Unit: metric (US)
- Pressure Ratio 15/1
- Maximum Fluid Pressure 90 (1305) bar (psi)
- Maximum Air Pressure 6 (87) bar (psi)
- Air Consumption 2.8 (1.65) m/h (cfm)
- Weight 7.7 (17) kg (lbs)
- Maximum Temperature 60 (140) C (F)
- Weighted Sound Level 71.2 dBA
- Recommended Air Pressure 2-5 (29-72.5) bar (psi)
- Fluid Output at 30 cycles/mn 0.75 (0.2) I/min (gaI/mn)
- Fluid Output at 20 cycles/mn 0.5 (0.13) I/mn (gaI/mn
- Fluid Volume Per Cycles 25 cc
- Free Flow Rate 1.5 (0.39) I/mn (gaI/mn)
- Fluid Output at 15 Cycles 0.375 (0.01) I/mn
- Air Consumption at 30 Cycles/mn at 4 Bar (60 psi) 2.8 m/h (cfm)
- Displacement Per Cycle 25 (1.52) cc (cubic inch)
- Motor Type 245-4
- Air Inlet F3/8'' BSP/ F3/8'' BSP
- Fluid Outlet F 3/8'' NPS / MI/2 JIC
- Fluid Inlet F 1/2'' BSP / M26X125
- Hard Chrome Stainless Steel, Wetted Parts
- Number of cycles per liter of product 40 Sealing packing upper and lower GT polyethylene
- Height 57.5 (22.6) cm (in) Width 32 (12.6) cm (in) Depth 17 (6.69) cm (in) Wetted parts stainless steel
- Technologies GT Sealing
This technology represents a new generation of sealing designed to extend the life of a pump piston.
Cup Lub
A pump with a lubricant-filled cup on the top of the fluid section
2 Ball
2 ball pumping technology is highly utilized in fluid sections with one ball / seat for suction & the other ball / seat for feeding.
Triple Chrome Layer
This is a spesial treatment for very high sustainability & is applied to the piston of the fluid section of a pump
